how can I change one specific color into another ?

[aneuryzma]

Very newbie question: I need to change all the orange color into my image into green.

thanks

[Raven12388]

Hi there

if it is a basic image where all the orange is the same or very close then the easiest way is use the magic wand on a section of orange right click it and select simular that will highlight all the orange then pick you green color and the brush tool and re color it

your could also use the wand as above to select all the orange go to image ajustmants hue/saturation and change the orang to green using the sliders

regards
Brian

[Tomi]

Open your document, go to 'Select' > 'Color Range' then use the droplet tool to select the colour in your image you want to change then click ok. This will select every part of the image that is the same color as you selected. Works similiarly to the magic wand tool but get it all in one, saves a lot of hastle.

[Raven12388]

Hi tomi i guess ya learn summin new everyday i never knew it is slightly better than using the wand a little more presice thanks mate

[igjoe]

Ditto. Thanks for the tip. Something I was always wondering, but always forgot to ask

[Suffer]

Open your document, go to 'Select' > 'Color Range' then use the droplet tool to select the colour in your image you want to change then click ok. This will select every part of the image that is the same color as you selected. Works similiarly to the magic wand tool but get it all in one, saves a lot of hastle.

thanks